Ok Guys ive got my self a Arrow AX6 silver arrow kart with rotax motor, i was thinking i would like to update the plastic to get it looking a bit newer and was wondering if its possible to fit plastics from a AX8/9 or unico plastics?
Whats involved in fitting these if you can , do i have to change the sidepod bars etc etc?
cheers shane
Whats involved in fitting these if you can , do i have to change the sidepod bars etc etc?
cheers shane
Views: 716
Comments5
You just need to unscrew the nuts and bolts holding the pods on and if needed drill new holes into the new pods. That should be all you need to do. Obviously measure up the height of the pods when drilling so they dont drag along the ground ;)
if you want to fit the ax8/ax9 style pods you will probably need new side pod bars
Digging up an old thread, Â is it possible to fit ax9 nose cone and nassau panel to an ax6?
Can the ax6 chassis be used with other engines easily enough ie. Rotax or Leopard 125, or does it depend on the type of ax6 (if there is different versions? ) mine is currently running a 100s
Depends on the which chassis you've got Andrew. If you have a set of verniers, measure the diameter of the main chassis rails (the ones that run down the length of the kart. If they're 30mm, you can probably get it running reasonably well with a 125 motor on it, if they're 28mm... probably not so much.
I believe you can fit an AX9 nosecone to an AX6, but you have to cut the uprights out of the front crash bar and replace them with the nosecone fitting kit.
I saw a kart at the track today, ax6 fitted with x1 nose cone and nassau panel. Would this be a simple bolt on mod with the use of the different front bracket for the Nassau panel (which I noticed it also had)